Filter
Top Products
5. LOADING THE MEDIA
5- 10
How to Reload the Media when the Upper Unit is Lifted
When the Upper Unit is lifted in the event of an error during printing in Strip mode, reload the
media using the following steps. Printing can be restarted while minimizing waste of the media.
1. Open the Front Cover, Side Cover, and Upper Unit.
2. If printing is stopped due to an occurrence of an error, remove the failed label from the
backing paper.
3. Turn the knob of the Ribbon Shaft (Take-up side) to take up the ribbon of 100 mm or over.
4. Reload the media. Place the leading edge of the label 5 - 10 mm behind the leading edge of
the strip plate.
[Supplemental Remarks]
Be sure to place the leading edge of a label within this range. Failure to do this may cause a
feed error.
5 to 10 mm
Leading edge of Strip Plate
Leading edge of label