Filter
Top Products
- 20 -
EO1-11113
NOTE: DLL is possible only when the non-floating cashier feature is used.
Store Name/Message and Commercial Message Programming
Cashier Code and Name Programming
PLU Table Programming
Time/Date Setting
Amount Limit Setting for Function Keys
Salesperson Code and Name Programming
Tare Table and General Unit Weight Setting
PLU Preset-code Key Setting
Display Message Programming
Negative Amount Key Limit Amount Setting
Set Menu Table Programming
Terminal Connection Table Setting
%+ and %- Preset Rate Setting
Preset Rate Setting for Selective Itemizers
Foreign Currency Exchange Rate Setting
Tax Table Programming
GST Rate Setting
501
502
504
505
508
520
526
527
531
535
542
569
500
Remarks
NOTE below
Submode No.
DLL Job
5. DLL (Down-Line-Loading) OPERATIONS
In an in-line system (Master-Satellite system), most programming data are set on the Master Termi-
nal and down-line-loaded (DLL) to Satellite Terminals. The DLL operations introduced in this chapter
are pure DLLs, i.e. merely loading the data programmed in the Master Terminal to Satellite Termi-
nals. DLLs automatically performed with programmed data changes are introduced in the next
chapter (Chapter 6). If any other DLLs not introduced in this and next chapters are required, ask
your TOSHIBA TEC representative. Please also note that TERMINAL DESIGNATION (see Chapter
2) can be operated prior to a specific DLL operation, to designate Satellite Terminals that receive the
DLL.
DLL JOB LIST