Toshiba KD-1025 Paper Shredder User Manual


 
GENERAL PRECAUTIONS FOR INSTALLATION/SERVICING/
MAINTENANCE
The installation and service shall be done by a qualified service technician.
1. When installing the Paper Feed Pedestal KD-1025 to the equipment, be sure to follow the
instructions described in the "Unpacking/Set-Up Procedure for the KD-1025" booklet which comes
with each unit of the KD-1025.
2. The KD-1025 should be installed by an authorized/qualified person.
3. When transporting/installing KD-1025, employ two persons and be sure to use the positions as
indicated below.
KD-1025 is fairly heavy and weights approximately 21 kg (46.3 lb.), therefore pay full attention when
handling it.
4. Before starting installation, servicing or maintenance work, be sure to turn OFF and unplug the
equipment first.
5. Be sure to fix and plug in the power cable securely after the installation so that no one trips over it.
6. The equipment shall be installed near the socket outlet and shall be accessible.
7. Unplug the power cable and clean the area around the prongs of the plug and socket outlet once a
year or more. A fire may occur when dust lies on this area.
8. The KD-1025 is supplied with power from the equipment, requiring no additional power source.
9. The KD-1025 should be grounded to the specified positions on the machine frame.
10.When servicing or maintaining the KD-1025, be careful about the rotating or operating sections such
as gears, pulleys, sprockets, cams, belts, etc.
11.When servicing the machines with the power turned ON, be sure not to touch live sections and
rotating/operating sections.
12.When parts are disassembled, reassembly is basically the reverse of disassembly unless otherwise
noted in this manual or other related materials. Be careful not to reassemble small parts such as
screws, washers, pins, E-rings, toothed washers to the wrong places.
13.Basically, the machine should not be operated with any parts removed or disassembled.
14.Delicate parts for preventing safety hazard problems (such as thermofuses, door switches sensors,
etc. if any) should be handled/installed/adjusted correctly.
15.Use suitable measuring instruments and tools.