Filter
Top Products
KD-1025 © 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 12
(4) Remove 2 screws and take off the bracket of
the feeding gear.
Note:
Match the protruding portion of the clutch
with the position shown in the figure for
assembling.
Fig. 4-30
(5) Disconnect the connector of the lower
drawer tray-up motor and remove 2 harness
clamps from the bracket.
Fig. 4-31
(6) Remove 2 screws and take off the tray-up
motor along with the bracket.
Fig. 4-32
Protrusion
Bracket