Filter
Top Products
KD-1025 © 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 14
(3) Remove the belt.
Fig. 4-36
Note:
When installing the belt, be sure to confirm
the gap between the belts with the following
procedure.
1. Install the belt in KD-1025.
2. Tighten 1 fixing screw of the tensioner
bracket.
3. Confirm that the gap between the belts is
approx. 3 mm.
Fig. 4-37
(4) Remove 1 connector and take off the PFP
motor assembly.
Fig. 4-38
Fixing screw
Approx.3mm
Connector
PFP motor assembly