Filter
Top Products
KD-1025 © 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved
PERIODIC MAINTENANCE
6 - 2
* c1. Separation roller
Apply an even coat of grease (Alvania No.2) to all round the inside of the spring. When replacing the
separation roller, apply adequate amount of white grease (Molykote HP-300) on the places of the
holder shown in the figure (4 places).
Note:
Make sure that the grease does not adhere to the roller surface. Wipe it off with alcohol if
adhered.
* c2. Drive gears in the paper feeding section (teeth of gears and shafts)
Apply some white grease (Molykote EM-30L) to the teeth of gears and shafts of the drive gears.
Note:
Make sure that oil is not running over or scattered around as the gear is rotated coming into the
clutch after applying Molykote to the gear which is located near the clutch. The quantity of
Molykote should be smaller than that to be applied to the other parts.
Fig. 6-2
Fig. 6-3
Apply grease
on the inside entirely
Separation roller
Lever
Holder
Separation roller