6. PROGRAMMING OPERATIONS
EO1-11152
6.4 Store Name Message and Commercial Message Programming (Submode 1)
6- 9
6.4 Store Name Message and Commercial Message Programming
(Submode 1)
Store Name Message and Commercial Message to be printed on the receipt can be programmed here.
Any time outside a sale
Mode Lock:
SET
1
[X]
|Line No.
|
[ST]
Character Entries
[ST]
[AT/TL]
NOTES: 1. For each line, a maximum of 32 regular-sized characters or 16 double-sized characters can be
entered. A combination of both types is also available.
2. When blanks are entered for the whole one line, it results in one line feed.
3. If no commercial message is required on the receipt, program blanks for all three lines. As a
result no extra lines will be fed. If any one of the three lines is programmed, the two other lines
will cause line feeds.
4. The 4-line range assigned for the store name/message will be either printed or fed, regardless of
any system option selection.
5. If any incorrect characters have been programmed, depress the [C] key to clear all the
characters on a line and then re-enter characters from the beginning, or end the line with an [ST]
and re-program the entire line. The new data will be active.
6. When all the lines have been programmed, do a check by issuing a receipt. Only the lines with
errors need to be re-programmed; other lines will not be affected.
Example)
To program the following Store Message and Commercial Message
Max. 32 characters/line
(See Section 6.2 Characte
r
Entries.)
1 digit (1 to 7)
1 to 4: Store Name Message
5 to 7: Commercial Message
(For sequentially programming lines, the
line number specification can be skipped.)
Repeat for another line.
To complete this line. To complete this
programming
operation.
OPERATION
CONDITION
Line No. 1
Line No. 2
Line No. 3
Line No. 4
Line No. 5
Line No. 6
Line No. 7
T E C S T O R E
1 3 4 3 P E A C H D R I V E
P H O N E : 8 7 - 6 4 3 7
O p e n 8 : 0 0 a m t o 7 : 0 0 p m
C l o s e d : e v e r y W e d n e s d a y
Store Name/Message
portion
Commercial Message
portion