Filter
Top Products
5. PROGRAMMING OPERATIONS
EO1-11152
5.2 Programming Operations Added for In-line Terminals
5- 4
NOTES: 1. Network Status Table
Code Item Set Reset
0 No Status
1
2
3
4
5 Default Gateway Used Not used
6 Subnet Mask auto-setting Ineffective Effective
7
8
In the above table, only Code 5 and Code 6 can be set.
Code 5: This code should be set before performing Default Gateway setting (6 [ST]).
Code 6: When this code is set, the Subnet Mask setting (5 [ST]) will be effective.
When this code is reset, the Subnet Mask auto-setting will be performed as follows.
IP Address first section value Subnet Mask
0 to 127 255. 0. 0.0
128 to 191 255.255. 0.0
192 to 223 255.255.255.0
2. Self IP Address, IP Address of Master terminal, Subnet Mask, and Default Gateway are
programmed with 12-digit value (000..000 to 255..254), respectively.
Example) To program “192.168.0.250”, enter 192168000250.
Initial setting values of the Self IP Address and the Default Gateway are as shown below.
Self IP Address: 192.168.0.254
Default Gateway: 192.168.0.1
3. Never assign the same In-line ID to terminals on the same In-line system.
Example) To assign Terminal ID No. 4 to the Terminal used as the Satellite Terminal of the in-line system:
In-line ID No.: 04
Network Status: No Status
IP Address: 192.168.0.200
IP Address of Master Terminal: 192.168.0.250
Subnet Mask: 255.255.255.0 (Default)
Default Gateway: 192.168.0.1 (Default)
Key Operation:
Mode Lock
SET
and IN-LINE Lamp illuminated,
enter 77, depress
[@/FOR]
.
1
[ST]
04
[#]
(In-line ID No.)
2
[ST]
0
[#]
(Network Status)
3
[ST]
192168000200
[#]
(IP Address)
4
[ST]
192168000250
[#]
(Master IP Address)
[AT/TL]
(Complete this Submode)