Filter
Top Products
3-12 Satellite P200/Satellite Pro P200
Getting Started
Restoring the pre-installed software from your
created Recovery Discs
If the pre-installed files are damaged, you are able to either use the Recovery
Discs you have created or the hard disk drive recovery process to restore
the computer to the state it was in when you originally received it. To perform
this restoration, follow the steps below:
1. Load the Recovery Discs into the optical disc drive and turn off the
computer's power.
2. While holding down F12 key on the keyboard, turn on your computer -
when the In Touch with Tomorrow TOSHIBA logo screen appears,
release the F12 key.
For 2HDD Model, If HDD1 is first, go to step 3. If HDD1 is not first, do
as follows:
■ Select <Enter Setup>
■ Press the F9 key to set to default settings, and select the [Yes].
■ When the "In Touch with Tomorrow TOSHIBA "prompt appears,
press the F12 key to display the Boot menu. Continue with step 3.
3. Use the left and right cursors key to select the optical disc drive icon
from the menu. Please refer to the Boot Priority section in Chapter 7,
HW Setup for further information.
4. A menu will be displayed from which you should follow the on-screen
instructions.
When the sound mute feature has been activated by pressing the Fn + Esc
key, be sure to disable this to allow sounds to be heard before starting the
restore process. Please refer to Chapter 5, The Keyboard, for further details.
When you reinstall the Windows operating system, the hard disc will be
reformatted and all data will be lost. You can not use System Recovery
Options if restoring the pre-installed software without System Recovery
options.
When removing pre-installed drivers / utilities or when installing, you can
setup the respective drivers / utilities from the following folder.
C: \TOSAPINS\***
When Installing TOSHIBA SD Memory Card Format or other SD utilities,
select TOSHIBA SD Memory Utilities from C:\TOSAPINS\.