UTStarcom UT-300R2 Network Card User Manual


 
Chapter 2 Installation Planning
7
Rear Panel
Figure 3
Rear Panel
ADSL port -
Connect to the
ADSL line
Ethernet port - to your
PC’s Ethernet port
Factory Reset
Button
Power input - Connect
power adapter here
Cable Connections
After verifying proper environmental conditions such as
temperature, humidity and power supply, users may start the
cable connections as following.
Connecting the ADSL Line
Use the ADSL cable included with the UT-300R2 to connect it
to a telephone wall socket or receptacle. Plug one end of the
cable into the ADSL port (RJ-11 receptacle) on the rear panel of
the UT-300R2 and insert the other end into the RJ-11 wall
socket. If you are using a low pass filter device, follow the
instructions included with the device or given to you by your
service provider. The ADSL connection represents the WAN
interface, the connection to the Internet. It is the physical link to
the service provider’s network backbone and ultimately to the
Internet.