UTStarcom UT-300R2 Network Card User Manual


 
Chapter 4 Web-based Management
37
Figure 16
Configure LAN IP settings
To change the
LAN IP Address
or
Subnet Mask
, type in the
desired values and click the
Apply
button. The new IP settings
must be saved and the UT-300R2 must be restarted for the
settings to go into effect. To manually Save & Restart the UT-
300R2, click on the
Tools
directory tab and then click the
System
menu button. Then click the
Save&Restart
button. The
UT-300R2 will save the new IP settings and restart. Your web
browser should automatically be redirected to the new IP
address.
Save New Settings
Most changes that require updating the UT-300R2’s non-volatile
RAM will automatically trigger a save and reboot proceedure.
Any changes you have made that you want to be saved to the
UT-300R2’s memory can be saved using the
System Setting
page, as shown below. To save settings you need to access the
System menu. Click on the Tools directory tab then click the
System
menu button to view the menu pictured below.