Filter
Top Products
14 © 2007 VBrick Systems, Inc.
Decoder Configuration
Player Settings
IP Address Specifies the unicast or multicast IP address that the SAP will be
sent to.
Port Specifies the IP port that the SAP will be sent to.
Note Be aware that any changes to the Video Output Settings
(see below) on the decoder
configuration page will reboot the IPR resulting in a brief loss of connectivity.
Minimum Buffer Size Default = 262144 bytes. This setting will allow more data to be
saved before it is displayed. This can be used in networks where
there is a high delay or congestion in the backbone. This parameter
should generally be left at the default value. However, if a stream
will not open, try setting at a higher value.
Buffer Duration Default = 1000 ms.
Output Volume Use to set default output volume. This can be overridden, adjusted,
or muted using the IR Remote Control.