Filter
Top Products
16 © 2007 VBrick Systems, Inc.
Admin Interfaces
The Admin Interfaces are enabled by default. Be aware that if you disable the Admin Pages
you will not be able to configure the IPR; if you disable the Web Service you will not be able
to upgrade the IPR. If you disable both these interfaces, it will be difficult to regain control.
Contact VBrick Support Services for more information.
Passwords
The WM IPR has two privilege levels: admin and public. Admin users can set or change any
parameter. Only one admin user can be logged in at a time; additional admin users will not be
allow to log in. Public users have read-only access.
Upgrade Configuration
These settings are used to identify the FTP server that will be used for a manual IPR upgrade.
In most cases you will use the
ETV-IPRDownload application (see Software Upgrade on
page 27) to upgrade IPR software. This application lets you automatically upgrade one or
more IPRs and provides detailed information and feedback. However you can also use the
Pull-Upgrade Settings explained below to run a manual upgrade on a single device. After
setting these parameters, go to the Maintenance page and click Upgrade.
FTP Server Enables access to the FTP server for Local mode. Default = enabled.
Admin Pages Enables access to the Admin pages. Default = enabled.
Web Service Enables access to the IPR web service. Use to control the IPR via an
application other than IWS. Default = enabled.
Session Timeouts Defines the time period in minutes before an admin session times out.
Default = 15.
Admin Username Default =
admin.
Admin Password Default =
admin.
Public Username Default =
public.
Public Password Default =
public.