Filter
Top Products
Warnings and Cautions:
No Serviceable Parts Inside; Authorized Service Personnel
Only
Do not attempt to repair or service this device yourself. Internal components must be serviced by
authorized personnel only.
Shock Hazard - Do Not Enter●
Choc Hasard - N'entrent●
Schocke Hazard - Test Nicht Betrete●
Otro Hazard - Do Non Entrano●
Nameplate Power Warning
This device should only be operated with the type of power source indicated on the instrument
nameplate. If you are not sure of the type of power service available, consult your local power
company.
Connect unit only to a properly measured supply. Use only three wire cord which is
provided with the unit.
●
Abouchent unité qu'aux convenable mesura approvisionnement. Usage qu'à trois fil
corde laquel est approvisionna avec la unité.
●
Anschliesse einheit nur bis ein angebracht gemessen nachschub. Gebrauch nur drei
draht schnur welche ist verschaffen mit das einheit.
●
Connect unità solo a un proper misurata fornirle. Adoperano solo tre wire spago
quale è fornii con gli unità.
●
Battery Replacement
This device may include a lithium battery powered circuit. If the battery is incorrectly replaced
or mistreated, there is a danger of explosion and a risk of personal injury. Do not attempt to
recharge the battery, disassemble it, immerse it in water, or dispose of it in a fire. Battery
replacement may only be performed by authorized service personnel.
Rack Mount Installation
When installing this device in an instrument rack, the following factors must be accounted for:
Enclosed Racks: Enclosed racks must provide adequate ventilation. Make certain that the
rack is not overly crowded and note that each unit in the rack generates its own heat. An
enclosed rack should have louvered sides and a fan to circulate cooling air. The maximum
temperature for the equipment in this environment is 45° C.
1.