Filter
Top Products
When using the wild card address "255.255.255.255" to block access by all
IP addresses, make certain that at least one higher priority mask permits
access by your IP address.
●
5.6. Copying Parameters to All Ports
The /CP command (Copy Port Parameters) provides a convenient means for selecting identical
(or similar) parameters for all CMS RS-232 ports.
When the /CP command is invoked, the unit will display a menu which allows you to select port
communication parameters, and then copy them to all CMS RS-232 ports. The Copy Port
Parameters menu can be used to set all parameters for all RS-232 Ports, or define only a select
group of parameters and then copy them to all ports.
Note:
The /CP command will not copy parameters to the Network Port.●
The /CP command is only available in Supervisor Mode.●
The Copy Port Parameters Menu will not display the Port Password. This
field will read either "undefined" or "defined", depending upon whether or
not the Port Password has been specified.
●
To select common parameters for all CMS RS-232 ports, proceed as follows:
Access the CMS command mode. If the password prompt is displayed, key in your
Supervisor Level Password.
1.
At the command prompt, type /CP and press [Enter], the menu shown in Figure 5.5 will
be displayed.
COPY PORT PARAMETERS:
1. Port Name:
2. Password: (undefined)
3. Baud Rate:
4. Bits/Parity:
5. Stop Bits:
6. Handshake Mode:
7. Port Mode:
74. DTR Output:
8. Supervisor Mode:
9. Logoff Character:
10. Sequence Disconnect:
11. Timeout Disconnect:
12. Response Type:
13. Command Echo:
14. Accept Break:
2.