Filter
Top Products
/UF Upgrade Firmware
When new versions of the CMS operating firmware become available, this command is used to
update the existing firmware as described in Section 9. Note that this command will only
function at the Network Port and at Setup Ports One and Two.
Availability: Supervisor Only
Format: /UF [Enter]
Response: The CMS will display a menu which offers the options to retain existing CMS
parameters, default parameters, or abort the upgrade procedure.
/W Display Port Parameters (Who)
Displays configuration of an individual port, but does not allow the user to change parameters.
Ports with User Level command capability cannot display parameters for other ports. Normally,
the Port Parameters screen will not include the Port Password. Note however, that when the
Supervisor Mode is active, the /WP option can be used to display the password for the target
port. For more information, please refer to Section 6.4.
Availability: Supervisor / User
Format: /W[P] [x] [Enter]
Where:
P
When the "P" option is included (e.g. /WP 5), the Port Parameters screen will list the
password for each port, if defined. (Supervisor Mode Only).
x
Is the port number or name. To display parameters for the Network Port, enter an "N". If the
"x" argument is omitted, parameters for your resident port will be displayed.
Response: Displays port parameters.
Example: To display parameters for a port named "SERVER", access the Command Mode from
a port with Supervisor Level command capability, and type /W SERVER [Enter].
/X Exit Command Mode
Exits Command Mode, When issued at the Net Port, also ends the telnet session. Note that
exiting from Command Mode will not terminate port connections.
Any-to-Any Mode: Exits Command Mode.●
Modem Mode: Disconnects and resets modem, hang-up message is sent, hardware line to
modem drops for 500 ms, and reset message is sent.
●