Filter
Top Products
XW System Accessories Installation
5–4 975-0239-01-01
4. Secure the mounting plate by tightening the two screws to rotate the tabs to the
horizontal position (see Figure 5-3) and pull the tabs tight against the inner surface of
the wall. Be careful not to overtighten the screws and damage the wall.
5. Connect the network cable(s) (and terminator if necessary) to either input on the back
of the XW System Control Panel. See Figure 5-4.
Connect a network terminator to the XW System Control Panel if it is the last device
at the end of a series-type network layout.
Figure 5-2
Inserting the Mounting Plate
Tabs in vertical position
Figure 5-3
Securing the Mounting Plate
Rotate tabs to
horizontal position
Important:
To ensure communication signal quality, the network must be terminated at each
end with a terminator.