Xantrex Technology XW4548-120/240-60 Power Supply User Manual


 
The XW Automatic Generator Start
975-0239-01-01 5–7
Verifying the Installation
If network power (from an inverter/charger) is present, the backlight will come on and the
XW System Control Panel will show the startup screen (see the XW Inverter/Charger
Operation Guide), then show the System Home screen.
The XW Automatic Generator Start
Some generators allow automatic starting. Connecting an Automatic Generator Start to the
generator and to the Xanbus network is required for the XW System to benefit from
automatic generator start/stop capability.
Preparing an Installation
Before installing the XW Automatic Generator Start Module, consider how and where the
unit will be mounted. Pre-plan the connection routes between the XW Automatic
Generator Start, the generator, thermostats, and the XW Automatic Generator Start. Refer
to the XW AGS Owner’s Guide for additional information.
See Chapter 3, “Xanbus Network Installation”, for more information about installing a
Xanbus-enabled device as part of a network-managed power system.
Materials and Tools Required
The following tools and materials may be needed to install the XW Automatic Generator
Start:
Mounting template (supplied)
Wiring harness (Xantrex part number 809-0917, supplied)
Four #6 screws, 1¼ inch (supplied)
WARNING: Shock Hazard
Auto-start generators can start automatically at any time.
Affix the warning labels (supplied with the XW Automatic Generator Start) regarding auto-start
generators on or near the main AC distribution panel and near the generator.
Figure 5-7
Connecting the AGS Communications Cable to the XW Series
The AGS connects to:
• Inverter/Charger’s Xanbus port
• Generator
Automatic Generator Start