Yamaha CRW2200S Personal Computer User Manual


 
Front and Rear of Unit
10
Jumper switch
Plug a plastic shunt into this jumper switch to set up SCSI ID, Parity, Terminator and
Block Size. (
P.20–23)
SCSI INTERFACE connector
Insert the connector of the SCSI ribbon cable here. (P. 26, 33)
DC IN connector (The SCSI convertor’s side)
Insert the smaller connector of the power cable (included). (P. 19, 34)
DIGITAL AUDIO OUT connector
If your sound card has a SPDIF (digital audio) input connector, you can connect the
DIGITAL AUDIO OUT connector of the unit to the SPDIF connector using a digital audio
cable (sold separately). (P. 17, 34)
ANALOG AUDIO OUT connector
Connect one end of the 4-pin audio cable to this connector, and the other end to your
computer’s sound card or built-in audio. (
P. 16, 34)
DC INPUT connector (The CRW2200 drive’s side)
Insert the bigger connector of the power cable (included). (P. 19, 34)
Rear Panel (with the SCSI Convertor)