Yamaha CRW2200S Personal Computer User Manual


 
SCSI Connection Set Up
20
Setting the Jumper Switches
8
88
8
Before fitting the CRW2200S into the computer, you need to set up the
driveusingthejumperswitcheslocatedattherearoftheunit.You’ll
need to set the following:
SCSI ID number
Parity check
Termination
Block size
To set each jumper switch, you have to bridge the two pins in the respective
column of the grid with a plastic shunt. Shunts are already attached to the jumper
switches in their default configurations.
Note
The plastic shunts actually contain metal for bridging the two pins of a jumper switch,
creating an electrical connection between them when attached. When removed, the jumper
switch is set to “OFF.” Store unused shunts in a safe place where they will not be lost.
Use a pair of long-nosed pliers to attach or detach the plastic shunts
accordingly. Make sure that the computer is turned off beforehand.
ID SELECT
PARITY.
TERMINATOR
BLOCK SIZE
124
Jumper switches
Rear Panel