Filter
Top Products
8
◆Loading the batteries into the remote control
1. Remove the battery compartment cover.
2. Insert two batteries (AA, UM3, or R6 type), matching the polarity
markings on the batteries with those in the battery
compartment.
3. After loading the batteries, close the cover until it snaps into
place.
Warning
• If the remote control must be used closer to the main unit than normal, or does not always operate correctly, exchange the
batteries for new ones.
• Do not mix old and new, or different types of batteries.
• Remove the batteries if you do not plan to use the unit for a long time.
• If the batteries leak, dispose of them immediately, taking care not to touch the battery fluid. If the battery fluid comes into contact
with your eyes, mouth, or skin, rinse it off with water immediately and consult a doctor. Clean the battery compartment thoroughly
before installing new batteries.
◆Using the remote control with a wired connection
Use a 2P monaural miniplug cable (commercially available) to connect the remote control jack on the underside of the remote control to the
REMOTE IN jack on the main unit. Use the wired remote control configuration to control the DPX-1100 without having to be within range
of the remote sensor.
1
3
2
I
R
I
S
V
.P
O
S
A
U
T
O
P
A
T
T
FOCUS
Z
O
O
M
S
E
T
T
I
N
G
ID-2
ID-1
R
E
S
E
T
H
I
D
E
S
T
I
L
L
S
V
ID
E
O
V
ID
E
O
B
A
D4
4
5
6
1
2
3
HDMI
M
EM
OR
Y
IN
PUT
L
IG
H
T
IN
P
UT
M
E
N
U
E
S
C
A
P
E
A
S
P
E
C
T
HDMI
G/Y B/PB/CB R/PR/CR
INPUT A
HD/SYNC
VD
OUT IN
REMOTE
TRIGGER OUT
S-VIDEO VIDEO
INPUT B
RGB/YP
BPR/YCBCR
RS-232C
D4 VIDEO
11_DPX-1100_E.p65 2004.04.16, 12:558