Filter
Top Products
10
Before projection, install the main unit and a screen, connect the main unit to an AV component or computer, and adjust the projection image.
You can begin projection as soon as installation is complete.
Refer to the sections below for information on how to install the main unit to suit your viewing environment.
◆If you have not installed the main unit or screen
• Immediately after purchase, when you have not installed either the main unit or a screen.
• When moving the main unit and screen to a new location.
◆If you have installed the main unit and screen, and connected a
source component
• You have installed the main unit and screen, and connected source components.
• You are using the main unit in a previously installed location with previously connected source components.
◆If you have installed the main unit and screen, but not connected
any image playback components
• You have installed the main unit and screen, but not connected any source components.
• You are using the main unit in a previously installed location, and wish to change the component you use as a signal source.
You do not need to carry out step 3 or step 4 if you
do not want to adjust the projection image. If the
unit does not project the image correctly, it may not
be connected correctly. In this case, carry out this
procedure starting from step 2.
STEP3
Select an image and
project.
☞ page 12 - 21
• The image is used
for adjusting the
image position
and focus.
STEP4
Adjust the
projection image.
☞ page 22 - 40
• Use the menu to
adjust projection
details.
Projection
preparations
complete
STEP2
Connect AV
components or a
computer to the
main unit.
☞ page 46
STEP3
Select an image and
project.
☞ page 12 - 21
• The image is used
for adjusting the
image position
and focus.
STEP4
Adjust the
projection image.
☞ page 22 - 40
• Use the menu to
adjust projection
details.
Projection
preparations
complete
STEP 1
Install the main unit
and screen.
☞ page 48
STEP3
Select an image and
project.
☞ page 12 - 21
• The image is used
for adjusting the
image position
and focus.
STEP2
Connect AV
components or a
computer to the
main unit.
☞ page 46
Projection
preparations
complete
5
Preparation
STEP4
Adjust the
projection image.
☞ page 22 - 40
• Use the menu to
adjust projection
details.
11_DPX-1100_E.p65 2004.04.16, 12:5510