Zebra S-Series User’s Guide 11
5LEERQ/RDGLQJ6H
Refer to Figure 4 throughout this procedure.
Note: When placing the ribbon roll on the ribbon supply spindle, make
sure that the core is pushed up against the stop on the ribbon
supply spindle and that the ribbon is aligned squarely with its
core. If this is not done, the ribbon may not cover the inside edge
of the printhead, exposing print elements to potentially damaging
contact with the media.
Do not load ribbon if the printer is to be used in the direct thermal
mode.
&$87,21'RQRW
XVHULEERQWKDWLVQDUURZHUWKDQWKHPHGLD,I
WKHSULQWKHDGLVQRWSURWHFWHGE\WKHVPRRWKEDFNLQJRIWKH
ULEERQH[FHVVLYHDEUDVLRQPD\FDXVHSUHPDWXUHSULQWKHDG
IDLOXUH
1. Align the segments of the ribbon supply spindle. See Figure 2.
Figure 2
2. Place the ribbon roll on the ribbon supply spindle.
3. Open the printhead by moving the handle to the OPEN position.