Filter
Top Products
72 Zebra S-Series User’s Guide
0HGLD+DQGOLQJ
• Tear-Off Mode: Produced in strips.
• Peel-Off Mode: Requires Peel-Off option or Media Rewind option.
Labels are dispensed and peeled from the liner, and the liner is rewound
internally.
• Rewind Mode: Requires Media Rewind option. A full roll of printed
labels is rewound internally.
• Cutter Mode: Requires Cutter Module option. Media cut after
printing; under software control.
0HGLD
Media Specifications 105Se 160S
Total media width
Maximum 4.5" 114.3 mm 7.2" 182.9 mm
Minimum 0.75" 19.05 mm 2.0" 50.8 mm
Label length
Maximum Refer to “Printing Considerations” on page 71.
Minimum
Tear-Off 0.63" 16.00 mm 0.63" 16.00 mm
Peel-Off 0.50" 12.8 mm 0.50" 12.8 mm
Rewind 0.50" 12.8 mm 0.50" 12.8 mm
Cutter 1.25" 31.75 mm N/A N/A
Total thickness
(includes liner)
Maximum (Printhead
position may need to be
adjusted above 0.01”)
0.015" 0.381 mm 0.015" 0.381 mm
Minimum 0.0023" 0.0584 mm 0.0023" 0.0584 mm
Core size 3.0" 76.2 mm 3.0" 76.2 mm
Maximum roll diameter 8.0" 203.2 mm 8.0" 203.2 mm
Interlabel gap (0.115”/3 mm preferred) 0.079" - 0.157" 2 mm - 4 mm 0.079" - 0.157" 2 mm - 4 mm
Maximum internal fanfold media pack size
(L x W x H)
8.0" x 7.2" x
6.2"
203.2 mm x 182.8
mm x 157.4 mm
8.0" x 7.2" x
6.2"
203.2 mm x 182.8
mm x 157.4 mm
Additional Specifications for Black Mark Media (optional on 105Se)
Mark thickness (measuring
parallel to label/tag edge)
Minimum 0.12" 3 mm 0.12" 3 mm
Maximum 0.43" 11 mm 0.43" 11 mm
Mark width (measuring
perpendicular to label/tag edge)
Minimum 0.43" 11 mm 0.43" 11 mm
Maximum Full media width. Full media width.
Mark-to-mark registration tolerance +/-0.016" +/-0.4 mm +/-0.016" +/-0.4 mm
Mark location Mark must be located on the inside of the media (closest to the printer’s
mainframe when loaded in the printer).
Mark density >1.0 ODU (Optical Density Unit)
Density of the back of the media on which the
black mark is printed
0.5 ODU maximum