Filter
Top Products
40 Zebra S-Series User’s Guide
%DQN
Note: For Serial Interface
Printers only.
The S-Series Printer, with the
RS-232 Serial Interface, uses eight
miniature switches located on the
rear of the printer above the signal
interface cable connector. The
ON/OFF positions of these
switches establish some of the
printer configuration parameters.
Bank 1 switches must be properly
positioned to establish serial data
communications with the host
computer. Thereafter, the position
of these switches should not be
changed.
Note: Parallel-interface printers
do not require these
configuration parameters,
therefore they have no
Bank 1 switches.
If these switches are in the proper
position to match the
communication configuration of
the host computer, and the printer
is not receiving data, refer to
“RS-232 Cabling Requirements”
on page 47 and make sure the
correct interface cable is being
used.
Note: The printer is fixed at 1
stop bit, so make sure
that your host device is
also set at 1 stop bit.
Table 1