Zebra Technologies 105S Printer User Manual


 
44 Zebra S-Series User’s Guide
$GMXVWLQJWKH3ULQW'DUNQHVV
This procedure sets the darkness of the printing on the label. Use the
lowest setting that provides the necessary print quality.
1. Press the MODE key. PAUSE and DARKEN lights turn ON.
2. Press UP or DOWN to adjust the current setting.
3. Press the MODE key three times. The MODE lights flash ON and
OFF to indicate that the settings have been saved in memory.
4. Press PAUSE to exit PAUSE mode. PAUSE light turns OFF.
$GMXVWLQJWKH0HGLD5HVW3RVLWLRQ
This procedure sets the end-of-label position relative to the tear-off bar or
cutter.
1. Briefly press the MODE key twice. PAUSE and POSITION lights
turn ON.
2. Press UP or DOWN to adjust the current setting.
3. Briefly press the MODE key twice. The MODE lights flash ON and
OFF to indicate that the settings have been saved in memory.
4. Press PAUSE to exit PAUSE mode. PAUSE light turns OFF.
$GMXVWLQJWKH3RVLWLRQRIWKH7RSRIWKH/DEHO
This procedure positions the printing on the label relative to the top edge
of the label.
1. Briefly press the MODE key twice, then press and hold for about five
seconds until the lights change. PAUSE, DARKEN, and
CALIBRATE lights turn ON.
2. Press UP or DOWN to adjust the current setting.
3. Briefly press the MODE key twice. The MODE lights flash ON and
OFF to indicate that the settings have been saved in memory.
4. Press PAUSE to exit PAUSE mode. PAUSE light turns OFF.