Filter
Top Products
Zebra S-Series User’s Guide 17
7HDU2II0RGH
Follow the instructions described in “Roll Media” on page 15.
5HZLQG0RGH
Note: Rewind option required.
To initially configure the printer for this mode, follow these steps:
1. Remove the media rewind plate from its storage location in front of
the printhead inside the media compartment.
2. Invert the rewind plate so that the lip on the attached hook plate points
down.
3. Insert the hook plate lip a short distance (1/2") into the lower opening
in the side plate.
4. Align the upper end of the rewind plate with the corresponding
opening in the side plate and slide the rewind plate in so that it stops
against the main frame.
5. Remove the hook from the take-up spindle shaft.
6. Route the media as shown in Figures 5 and 6 and wind it 1-2 times
around a 3" core.
3HHO2II0RGH
1. Remove the rewind plate if one is present and store it on the two
mounting screws on the inside of the front panel. Align the notch or
web in the media so that the take label sensor can sense a peeled label.
2. Load media as shown in Figures 5 and 6.
3. Remove the hook from the take-up spindle shaft.
4. Remove several labels from the media backing and then wind the
backing 1-2 times around the media take-up spindle and reinstall the
hook.