Zebra Technologies 105S Printer User Manual


 
32 Zebra S-Series User’s Guide
)(('.H\6HOI7HVW
Note: The CANCEL Key Self Test should be performed before this self
test. Information on the configuration printout (see Figure 12 on
page 30) can be used with the results of this self test to determine
the best darkness setting for a specific media/ribbon combination.
The FEED Key Self Test prints out at various darkness settings above and
below that of the darkness value shown on the configuration label. Inspect
these labels and determine which one has the best darkness setting for the
application. This value can be entered into the printer by setting the
darkness during the configuration procedure.
The value printed on the FEED
Key Self Test label is added to
(plus) or subtracted from
(minus) the “Darkness” value
specified on the configuration
label. The resulting numeric
value (0 to 30) is the best
darkness value for that specific
media/ribbon combination.
The darkness value can also be
programmed into the ZPL II
formats sent to the printer.
Figure 14