Filter
Top Products
ZyWALL 10/50 Internet Security Gateway
18-16 Filter Configuration
When you press [ENTER] to confirm, you will see the following screen. Note that there is only one filter
rule in this set.
Figure 18-12 Example Filter Rules Summary — Menu 21.1.3
After you’ve created the filter set, you must apply it.
Step 1. Enter 11 from the main menu to go to menu 11.
Step 2. Go to the Edit Filter Sets field, press [SPACE BAR] to select Yes and press [ENTER].
Step 3. This brings you to menu 11.5. Apply a filter set (our example filter set 3) as shown in Figure
18-15.
Step 4. Press [ENTER] to confirm after you enter the set numbers and to leave menu 11.5.
Menu 21.1.3 - Filter Rules Summary
# A Type Filter Rules M m n
- - ---- --------------------------------------------------------------- - - -
1 Y IP Pr=6, SA=0.0.0.0, DA=0.0.0.0, DP=23 N D F
2 N
3 N
4 N
5 N
6 N
Enter Filter Rule Number (1-6) to Configure: 1
This shows you that you have
configured and activated (A = Y) a
TCP/IP filter rule (Type = IP, Pr = 6)
for destination telnet ports (DP =
23).
M = N means an action can be taken immediately.
The action is to drop the packet (m = D) if the
action is matched and to forward the packet
immediately (n = F) if the action is not matched no
matter whether there are more rules to be
checked (there aren’t in this example).