Filter
Top Products
ZyWALL 10/50 Internet Security Gateway
Remote Node Setup 7-9
Figure 7-5 Menu 11.3 — Remote Node Network Layer Options
The next table gives you instructions about configuring remote node network layer options.
Table 7-5 Remote Node Network Layer Options Menu Fields
FIELD DESCRIPTION EXAMPLE
IP Address
Assignment
If your ISP did not assign you an explicit IP address, select Dynamic;
otherwise select Static and enter the IP address & subnet mask in
the following fields.
Dynamic
Rem IP
Address
If you have a Static IP Assignment, enter the IP address assigned
to the remote node.
192.168.1.1
Rem IP Subnet
Mask
If you have a Static IP Assignment, enter the subnet mask assigned
to the remote node.
255.255.255.0
My WAN Addr Some implementations, especially the UNIX derivatives, require the
WAN link to have a separate IP network number from the LAN and
each end must have a unique address within the WAN network
number. If this is the case, enter the IP address assigned to the WAN
port of your ZyWALL.
Note that this is the address assigned to your local ZyWALL, not the
remote router.
0.0.0.0
Network
Address
Translation
Use [SPACE BAR] to select either Full Feature, None or SUA Only.
See the NAT chapter for a full discussion on this feature.
SUA Only
Menu 11.3 - Remote Node Network Layer Options
IP Address Assignment= Dynamic
Rem IP Address= N/A
Rem Subnet Mask= N/A
My WAN Addr= 0.0.0.0
Network Address Translation= Full Feature
Metric= 1
Private= No
RIP Direction= None
Version= N/A
Multicast= None
Enter here to CONFIRM or ESC to CANCEL:
Press Space Bar to Toggle.