Filter
Top Products
ZyWALL 10/50 Internet Security Gateway
9-12 NAT
Table 9-5 Fields in Menu 15.1.1
FIELD DESCRIPTION EXAMPLE
Action
The default is None. Edit means you want to edit a selected rule
(see following field). Insert Before means to insert a rule before
the rule selected. The rules after the selected rule will then be
moved down by one rule. Delete means to delete the selected rule
and then all the rules after the selected one will be advanced one
rule. None disables the Select Rule item.
Edit
Select Rule
When you choose Edit, Insert Before or Delete in the previous
field the cursor jumps to this field to allow you to select the rule to
apply the action in question.
1
You must press [ENTER] at the bottom of the screen to save the whole set. You must
do this again if you make any changes to the set – including deleting a rule. No
changes to the set take place until this action is taken.
Selecting Edit in the Action field and then selecting a rule brings up the following menu, Menu 15.1.1.1 -
Address Mapping Rule in which you can edit an individual rule and configure the Type, Local and
Global Start/End IPs.
An End IP address must be numerically greater than its corresponding IP Start
address.
Figure 9-9 Menu 15.1.1.1 — Editing/Configuring an Individual Rule in a Set
Menu 15.1.1.1 Address Mapping Rule
Type= One-to-One
Local IP:
Start=
End = N/A
Global IP:
Start=
End = N/A
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle.