Filter
Top Products
ES-3148 User’s Guide
156 Chapter 22 VLAN Stacking
Figure 75 VLAN Stacking Example
22.2 VLAN Stacking Port Roles
Each port can have three VLAN stacking “roles”, Normal, Access Port and Tunnel (the latter
is for Gigabit ports only).
• Select Normal for “regular” (non-VLAN stacking) IEEE 802.1Q frame switching.
• Select Access Port for ingress ports on the service provider's edge devices (1 and 2 in the
VLAN stacking example figure). The incoming frame is treated as "untagged", so a
second VLAN tag (outer VLAN tag) can be added.
Note: Static VLAN Tx Tagging MUST be disabled on a port where you choose
Normal or Access Port.
• Select Tunnel (available for Gigabit ports only) for egress ports at the edge of the service
provider's network. All VLANs belonging to a customer can be aggregated into a single
service provider's VLAN (using the outer VLAN tag defined by SP VID).
Note: Static VLAN Tx Tagging MUST be enabled on a port where you choose
Tunnel.
22.3 VLAN Tag Format
A VLAN tag (service provider VLAN stacking or customer IEEE 802.1Q) consists of the
following three fields.
Table 48 VLAN Tag Format
Type Priority VID