Filter
Top Products
ES-3148 User’s Guide
202 Chapter 31 Introducing the Commands
To enter Enable (or privileged) mode, type enable and enter a password when prompted (the
default is 1234). When you enter the Enable mode, the command prompt changes to the pound
sign (
#).
To enter the configuration mode, type
configure or config. The Configure mode command
prompt consists of the word “
config” and the pound sign (#). There are various sub
configuration modes: interface, MVR and VLAN.
• To enter config-vlan mode, type
vlan followed by a number (between 1 to 4094). For
example,
vlan 10 to configure settings for VLAN 10.
• To enter config-interface mode and configure the ports, enter
interface port-
channel
followed by a port number. For example, interface port-channel 10.
• To enter MVR mode, enter
mvr followed by a VLAN ID (between 1 and 4094). For
example, enter
mvr 2 to configure multicast settings on VLAN 2.
Enter
exit or logout to quit from the current mode or log out from the CLI.
31.7 Using Command History
The switch keeps a list of up to 256 commands(s) you have entered for the current CLI
session. You can use any commands in the history again by pressing the up (y) or down (z)
arrow key to scroll through the previously used commands and press
[ENTER]. Use the history
command to display the list of commands.
Figure 112 CLI: History Command Example
31.8 Saving Your Configuration
After you set the switch settings with the configuration commands, use the write memory
command to save the changes permanently.
ras> history
enable
exit
show ip
history
ras>