Filter
Top Products
ES-3148 User’s Guide
Chapter 4 The Web Configurator 51
4.5 Resetting the Switch
If you lock yourself (and others) from the switch or forget the switch password, you will need
to reload the factory-default configuration file or reset the switch back to the factory defaults.
4.5.1 Reload the Configuration File
Uploading the factory-default configuration file replaces the current configuration file with the
factory-default configuration file. This means that you will lose all previous configurations
and the speed of the console port will be reset to the default of 9600bps with 8 data bit, no
parity, one stop bit and flow control set to none. The password will also be reset to “1234” and
the IP address to 192.168.1.1.
To upload the configuration file, do the following:
1 Connect to the console port using a computer with terminal emulation software. See
Section 3.1.1 on page 40 for details.
2 Disconnect and reconnect the switch’s power to begin a session. When you reconnect the
switch’s power, you will see the initial screen.
3 When you see the message “
Press any key to enter Debug Mode within 3
seconds ...
” press any key to enter debug mode.
4 Type
atlc after the “Enter Debug Mode” message.
5 Wait for the “
Starting XMODEM upload” message before activating XMODEM
upload on your terminal.
6 This is an example Xmodem configuration upload using HyperTerminal. Click Transfer,
then Send File to display the following screen.
Figure 18 Example Xmodem Upload
7 After a configuration file upload, type atgo to restart the switch.
Type the configuration file's
location, or click Browse to
search for it.
Choose the 1K Xmodem
protocol.
Then click Send.