Filter
Top Products
ES-3148 User’s Guide
234 Chapter 32 Command Examples
Figure 129 no ssh Command Example
32.8 interface Commands
These are some commonly used commands that belong to the interface group of
commands.
32.8.1 interface port-channel
Syntax:
interface port-channel <port-list>
Use this command to enable the specified ports for configuration. Type multiple ports or port
ranges separated by a comma. Ranges of port numbers are typed separated by a dash.
An example is shown next.
• Enter the configuration mode.
• Enable ports one, three, four and five for configuration.
• Begin configuring for those ports.
Figure 130 interface Command Example
32.8.2 bpdu-control
Syntax:
bpdu-control <peer|tunnel|discard|network>
ras(config)# no ssh key rsa1
ras(config)# no ssh known-hosts 172.165.1.8
ras(config)# no ssh known-hosts 172.165.1.9 ssh-rsa
ras# config
ras(config)# interface port-channel 1,3-5
ras(config-interface)#