ZyXEL Communications NSA210 Server User Manual


 
Chapter 20 Troubleshooting
Media Server User’s Guide
345
Use another Ethernet cable. If you’re connecting to a Gigabit Ethernet, make sure you’re using
an 8-wire Ethernet cable.
If the problem continues, contact the vendor.
See Section 21.1 on page 361 for a description of NSA LEDs.
The NSA turns off or reboots by itself.
Check the Power Management screen. This is where you configure power settings for the NSA,
including power saving, UPS, power on/off during power failure and power on/off schedule. The
NSA may be set to turn off under certain conditions.
A power failure occurred while the NSA is downloading files.
If power failure occurs during the active download period, the NSA will verify whether the
downloaded files were damaged.
If a file is corrupted, the NSA will download the file again.
If the file is intact but not completely downloaded, the NSA will resume the download task after
it restarts.
20.3 NAS Starter Utility
The NAS Starter Utility cannot discover my NSA.
Close the NAS Starter Utility and reopen it.
Check your hardware connections and make sure they are set up correctly.
Only one instance of the NAS Starter Utility can run on your computer. Make sure you close any
duplicate windows for this application.
Wait for the SYS LED to stop blinking before clicking Discover.
Confirm that the computer running the NAS Starter Utility has a network connection. See the
section on the NSA’s LAN connection for related information.
The computer running the NAS Starter Utility can only discover NSAs in the same subnet. NSAs
connected to the same switch or router as your NAS Starter Utility computer are usually in the
same subnet unless the router is doing subnetting or the switch is implementing VLAN.