Filter
Top Products
Prestige 791R G.SHDSL Router
Initial Setup 3-1
Chapter 3
Initial Setup
This chapter shows you how to set up your G.SHDSL connection using the SMT.
3.1 Configuring Your Prestige For Internet Access
Configure your Prestige for Internet access using:
SMT (System Management Terminal).
Web configurator (refer to the Quick Start Guide).
3.1.1 Procedure For SMT Configuration via Console Port
Follow the steps below to access your Prestige via the console port.
Configure a terminal emulation communications program as follows: VT100 terminal emulation, no parity,
8 data bits, 1 stop bit, data flow set to none, 9600 bps port speed.
Press [ENTER] to display the SMT password screen. The default password is “1234”.
3.1.2 Procedure For SMT Configuration via Telnet
The following procedure details how to telnet into your Prestige.
Step 1. In Windows, click Start (usually in the bottom left corner), Run and then type “telnet
192.168.1.1” (the default IP address) and click OK.
Step 2. Enter “1234” in the Password field.
Step 3. After entering the password you will see the main menu.
Please note that if there is no activity for longer than five minutes (default timeout period) after you log in,
your Prestige will automatically log you out. You will then have to telnet into the Prestige again.