Filter
Top Products
Prestige 791R G.SHDSL Router
5.2.2 Editing TCP/IP Options
Move the cursor to the Edit IP field in menu 11.1, then press [SPACE BAR] to select Yes. Press
[ENTER]
to open Menu 11.3 - Network Layer Options.
Figure 5-6 Remote Node Network Layer Options
Table 5-5 Remote Node Network Layer Options
FIELD DESCRIPTION EXAMPLE
Rem IP
Address
Leave this field set to 0.0.0.0 to have the ISP or other remote router
dynamically (automatically) send its IP address if you do not know it.
Enter the remote gateway’s IP address here if you know it (static).
0.0.0.0
(default)
Rem IP
Subnet
Mask
Leave this field set to 0.0.0.0 to have the ISP or other remote router
dynamically send its subnet mask if you do not know it. Enter the remote
gateway’s subnet mask here if you know it (static).
0.0.0.0
(default)
My WAN
Addr
Leave the field set to 0.0.0.0 to have the ISP or other remote router
dynamically (automatically) assign your WAN IP address if you do not
know it. Enter your WAN IP address here if you know it (static).
This is the address assigned to your local Prestige, not the remote
router.
0.0.0.0
(default)
NAT
Press [SPACE BAR] and then [ENTER] to select either Full Feature,
None or SUA Only. See the Network Address Translation (NAT) chapter
for a full discussion on this feature.
None
(default)
Metric Enter a number from 1 to 15 to set this route’s priority among the
Prestige’s routes. The smaller the number, the higher priority the route
has.
15
(default)
Menu 11.3 - Remote Node Network Layer Options
Rem IP Addr= 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
NAT = None
Metric= 15
Private= No
RIP Direction= Both
Version= RIP-2B
Multicast= None
Enter here to CONFIRM or ESC to CANCEL:
5-8 Dial Backup