Filter
Top Products
Prestige 642R Series ADSL Router
Remote Node Configuration 4-1
Chapter 4
Remote Node Configuration
In this chapter, we discuss the parameters that are protocol independent.
The protocol-dependent configurations are covered in subsequent chapters.
A remote node is required for placing calls to a remote gateway. A remote node represents both the remote
gateway and the network behind it across a WAN connection. Note that when you use Menu 4 to set up
Internet access, you are actually configuring one of the remote nodes.
4.1 Remote Node Setup
This section describes the protocol-independent parameters for a remote node.
4.1.1 Remote Node Profile
To configure a remote node, follow these steps:
Step 1. From the Main Menu, select menu option 11 - Remote Node Setup.
Step 2. When Menu 11 appears, as shown in the following figure, enter the number of the remote node
that you wish to configure.
Figure 4-1 Menu 11 - Remote Node Setup
Menu 11 - Remote Node Setup
1. ChangeMe (ISP,SUA)
2. ________
3. ________
4. ________
5. ________
6. ________
7. ________
8. ________
Enter Node # to Edit: