Filter
Top Products
Prestige 642R Series ADSL Router
Remote Node Configuration 4-5
Options
.
Rem IP Addr Enter the IP address of the remote gateway.
Edit IP/IPX/Bridge
Press [space bar] to select Yes and press [Enter] to go
to Menu 11.3 – Remote Node Network Layer
Options.
Yes or No
Session Options:
Edit Filter Sets
Press [space bar] to select Yes and press [Enter] to
open Menu 11.5 to edit the filter sets. See the Remote
Node Filter section for more details.
Yes or No
PPPoE Idle
Timeout
(sec) This value specifies the number of idle seconds that
elapse before the Prestige automatically disconnects
the PPPoE session.
100
(default)
PPPoE Service Name This is valid only when you have chosen PPPoE
encapsulation. If you are using PPPoE encapsulation,
then type the name of your PPPoE service here.
Once you have completed filling in Menu 11.1 – Remote Node Profile, press [Enter] at the message
[Press ENTER to Confirm … ] to save your configuration, or press [Esc] at any time to cancel.
4.1.3 Outgoing Authentication Protocol
Generally speaking, you should employ the strongest authentication protocol possible, for obvious reasons.
However, some vendor’s implementation includes specific authentication protocol in the user profile. It will
disconnect if the negotiated protocol is different from that in the user profile, even when the negotiated
protocol is stronger than specified. If you encounter the case where the peer disconnects right after a
successful authentication, please make sure that you specify the correct authentication protocol when
connecting to such an implementation.
4.1.4 Editing PPP Options
To edit the remote node PPP options, move the cursor to the Edit PPP Options field in Menu 11.1 –
Remote Node Profile, and use [space bar] to select Yes. Press [Enter] to open Menu 11.2, as shown
next.