Filter
Top Products
Prestige 642R Series ADSL Router
5-6 Remote Node TCP/IP Configuration
FIELD DESCRIPTION OPTIONS
Version
Press [space bar] to select the RIP version from RIP-1/
RIP-2B/RIP-2M.
RIP-1,
RIP-2B or
RIP-2M
Multicast Sets IGMP to version 1, version 2, or disables IGMP. IGMP
(Internet Group Multicast Protocol) is a session-layer protocol
used to establish membership in a Multicast group. The
Prestige supports both IGMP version 1 (IGMP-v1) and version
2 (IGMP-v2). Press [space bar] to enable IP Multicasting or
select None to disable it.
IGMP-v1/
IGMP-v2/
None (default)
IP Policies
Create policies using SMT Menu 25 (see the IP Routing Policy
Chapter in Part 3) and apply them on the Prestige LAN
interface here. You can apply up to four IP Policy sets (from
twelve) by entering their numbers separated by commas.
e.g., 3, 4, 5, 6
Once you have completed filling in the Remote Node Network Layer Options Menu, press [Enter] to
return to Menu 11. Press [Enter] at the message [Press ENTER to Confirm…] to save your
configuration or press [Esc] at any time to cancel.
5.1.2 Static Route Setup
Static routes tell the Prestige routing information that it cannot learn automatically through other means.
This can arise in cases where RIP is disabled on the LAN or a remote network is beyond the one that is
directly connected to a remote node.
Each remote node specifies only the network to which the gateway is directly connected and the Prestige
has no knowledge of the networks beyond it. For instance, the Prestige knows about network N2 in the
following diagram through remote node Router 1. However, the Prestige is unable to route a packet to
network N3 because it does not know that there is a route through remote node Router 1 (via Router 2). The
static routes are for you to tell the Prestige about the networks beyond the remote nodes.