Filter
Top Products
18 COREBUILDER 6000 EXTENDED SWITCHING SOFTWARE REVISION 8.2.3
For each slot that you enter, the system asks for specific port numbers:
Select Ethernet port(s) (1-8,all):
3 Enter the number(s) of the port(s) that you want to configure:
1,2,5-7
Default To select the default all, press Return.
Enter
enable or disable to select the IFM mode for each selected port:
Enter new value (disabled, enabled) [disabled]:
4 Enter enabled to set the port to IFM mode or disabled to deactivate IFM
for the port.
Default To select the port’s current setting, shown in brackets, press Return. This
action leaves the port setting unchanged.
5 Repeat step 4 to configure all selected ports in all selected slots.
Bridge MIB Support for the FESM
FESM support has been added to the Bridge MIB.
Filter MIB Support
To support Filter Builder software, this revision adds the Filter MIB (address
group, port group, and bridge packet filter program). See the Filter Builder
Getting Started Guide, which is shipped with the Filter Builder software, for
more information about the Filter Builder product.
FTP Packet Filter Program Transfers via SNMP
You can now use File Transfer Protocol (FTP) to transfer a user-defined
packet filter program from a remote server to a CoreBuilder switching
module through the SNMP lpsFtTable MIB.
Disconnecting an Active telnet or rlogin Session
Modifications to the telnet and rlogin features of the CoreBuilder 6000
system now allow you to preempt users by forcing a disconnection. This
administrative feature requires that you use the system Administer
password at the Administration Console.
The rlogin usage is identical to the telnet usage. Simply substitute rlogin
wherever you see telnet.