Filter
Top Products
A-4 APPENDIX A: IP MULTICAST ROUTING
Rate Limit
The rate limit determines how fast multicast traffic can travel over the
interface in kilobytes per second. Multicast traffic may not exceed this rate
limit or the CoreBuilder system will drop packets in order to maintain the
set rate. The default is set to 0, which implies no rate limit. In all other
instances, the lower the rate limit, the more limited the traffic over the
interface.
Displaying
Multicast Interfaces
To display a multicast interface:
1 From the top level of the Administration Console, enter:
ip multicast interface display
2 Enter the slot of the switching module from which you want to display a
multicast interface.
Select IP stack(s) by slot (2,3,7,9-12|all) [12]:
Enter the index numbers of the interfaces you want to display.
Example multicast interface configuration for the slot:
Top-Level Menu
system
ethernet
fddi
tokenring
bridge
➧ip
ipx
appletalk
snmp
analyzer
script
logout
interface
route
arp
➧multicast
udpHelper
routing
icmpRouterDiscovery
rip
ping
statistics
dvmrp
igmp
➧interface
tunnel
routeDisplay
cacheDisplay
➧display
enable
disable
Index Local Address Metric Threshold RateLimit State
1 158.101.112.32 1 1 0 queries
pkts in:0 pkts out:0
port 3 peers 158.101.112.204 (3.6) (0x8e)
158.101.112.202 (3.6) (0x8f)
port 3 groups 224.2.127.255 (3.6) (0x8e)
224.2.143.24
port 4 groups 224.2.143.24
224.2.127.225