Filter
Top Products
2
C
ORE
B
UILDER
6000 E
XTENDED
S
WITCHING
S
OFTWARE
R
EVISION
8.2.3
If you have an LMM+ at a revision earlier than 1.21 (for revision 1 modules)
or 2.12 (for revision 2 modules), call 3Com at 1-800-876-3266 and press
option 2. 3Com will replace your LMM+ with an LMM+ at the correct
revision, free of charge. (Contact 3Com at the same number to upgrade an
LMM to an LMM+. There is a fee for this upgrade.)
Extended Switching
Software
Requirement
Release 8.0.0 or greater of Extended Switching Software requires a
minimum of 2 MB of memory on Ethernet/FDDI Switching Modules
(EFSMs). Memory configuration may vary. If you have an EFSM with 1 MB of
memory, you can order a memory upgrade. Contact your sales
representative.
To determine the amount of memory on the EFSM, look at the lower ejector
tab label or use the
system display
command from the top level of the
Administration Console. EFSMs with only 1 MB of memory have blank
lower ejector tabs. EFSMs with a minimum of 2 MB of memory have “2MB”
on the lower ejector tab labels.
Release Highlights
for 8.2.3
CoreBuilder system software release 8.2.3 offers support for the following
items:
■
Software support for protocol-based VLANs
■
Support for seven RMON data groups
■
IP interface configuration change
■
Routing on FESM Modules
■
Additional RMON MIB support
■
RMON support for FDDI switched ports
For more information about this release, see “What’s New at Revision 8.2.3?”
on page 9.
Release Highlights
for 8.2.0
CoreBuilder system software release 8.2.0 supports the following items:
■
Fast Ethernet Switching Module (FESM)
■
FESM and FSM HSI Switch Engines
■
Ability to administer Fast Ethernet Ports
■
Bridge MIB support for the FESM