Filter
Top Products
26 COREBUILDER 6000 EXTENDED SWITCHING SOFTWARE REVISION 8.2.3
Known Problems The following software problems are identified at this release:
■ To compile lpv2.mib with a version 2 compiler, perform these steps:
1 In the IMPORTS section, add:
RowStatus FROM SNMPv2-TC
2 A few lines below, add the following RowStatus comment:
-- RowStatus ::== INTEGER (1..6)
The new IMPORTS section now looks like this:
LANPLEX-SYSTEMS-MIB-1-4-1 DEFINITIONS ::= BEGIN
IMPORTS
enterprises, Counter, Gauge, IpAddress FROM RFC1155-SMI
DisplayString FROM RFC1213-MIB
OBJECT-TYPE FROM RFC-1212
RowStatus FROM SNMPv2-TC
TRAP-TYPE FROM RFC-1215
-- Textual conventions
-- RowStatus as defined in SNMPv2
-- Refer to rfc1443.txt for concise definition
-- This is a place holder until lp.mib is fully compliant
with SNMPv2
-- RowStatus ::== INTEGER (1..6)
■ Do not create port groups and port group filters on the FESM or FSM.
■ The FESM and TMM-FE rxFrames, txFrames, rxBytes, and txBytes statistics
can report inaccurate values.
■ The FESM FDDI MAC rxFrames, txFrames, rxBytes, and txBytes statistics can
report inaccurate values.
■ CoreBuilder 6000 system software does not route FDDI multicast frames
that are larger than 1500 bytes (that is, frames that require fragmentation).
■ The NVRAM conversion for SNMP traps does not adjust correctly after you
install CoreBuilder software revision 8.2.3. Verify that the appropriate traps
are enabled.