Filter
Top Products
2-14 CHAPTER 2: INSTALLING THE NETWORK DRIVER
AutoLink for Windows 3.x, Windows for Workgroups,
and DOS
This section describes how to install the network driver for a
notebook running Windows 3.x, Windows for Workgroups,
and DOS using the 3Com AutoLink
™
program. The AutoLink
program automatically installs the NetWare ODI client
software (including the driver), and modifies the CONFIG.SYS
and AUTOEXEC.BAT files.
To use the AutoLink program, the notebook must use the
Novell NetWare 3.12, 4.10, or 4.11 network operating
system, and be a NetWare DOS ODI client.
1 Make sure the CardBus PC Card is installed and
connected to the network, as described in Chapter 1.
2 Boot the notebook under DOS.
3 Insert the LAN Installation Disk in the floppy drive,
and type the following at the DOS prompt:
a:\install [Enter]
4 Choose Auto Install and Config for NetWare (AutoLink).
An OS selection screen appears.
5 Select AutoLink for DOS, Windows 3.x, or WFW 3.11.
Several messages appear while the AutoLink program is
running. A final message indicates successful installation.
6 When prompted, remove the LAN Installation Disk
and reboot the notebook.
7 When prompted, type your user name and password
to complete installation.