Filter
Top Products
EtherHub 1500 System User’s Guide
3-10 Hardware Installation
In-Band Configuration
If you use AccView/Open or other network management
software to configure the EtherHub 1500, then set up your in-
band Network Management Station.
The in-band network management station is the personal
computer used to run your network management software. It
should be connected to any available RJ-45 port of the stacked
system and on the same segment as the SNMP management
agent.
Accton’s EtherHub 1500 System has Windows-based network
management software called AccView/Open. Any PC running
the AccView/Open program can serve as your in-band network
management station. Inquire with your Accton dealer on how
to acquire this package. Also note that the AccView/Open
EtherHub Manager can be integrated into third-party
management platforms as described in Chapter 1.
F
After hardware installation, you can also configure the hub using the
Configure button. For the EtherHub-16mi
+
, we recommend using
Accton’s in-band network management software (AccView/Open) or
the out-of-band program. Proceed to
Chapter 4
for details.
Installing an SNMP Backup Agent
If you are performing first time installation, just connect two
Agents and let the system automatically choose the Master
agent and the Slave agent.
If you are adding a slave agent to an existing system, peform
the following steps:
1. Before connecting to the system, set the target SNMP agent
to Slave mode using the Configure button. Be sure the
PWR/CPU LED is ON (i.e., blinking).