Filter
Top Products
EtherHub 1500 System User’s Guide
Setup and Configuration 4-13
Configuring Port Parameters
Use the Port command from the Control menu to configure the
ports for any hub in the stack. (Select the required hub using
the <F4> and <F5> function keys.) This menu provides a brief
description of the selected hub, and also allows you to
enable/disable any port in the selected hub.
Parameter Description
Hub ID Hub identifier within the stack.
Position The physical position in the stack.
Port Identifier
Numeric identifier 1~16 or ALT.
Name User-defined name for selected port.
Type Connection types include 10BASE-T (RJ-45), BNC, AUI or FIBER.
Status Any port may ENABLED or DISABLED.
Part Indicates if the port is partitioned.
Link State Indicates if the port has a valid connection to an external device.
Defining Backup Ports
Use the Backup Port command in the Control Menu to define
up to three master/slave port pairs. If the connection to the
master port fails, the slave port will automatically take over.
Parameter Description
Backup Set Defines up to three backup port pairs; each of which can be set to ACTIVE or INACTIVE.
Master Port Pair member serving as the primary link.
Hub Hub ID for the master port.
Port Port identifier for the master port.
Slave Port Pair member serving as the backup link.
Hub Hub ID for the slave port.
Port Port identifier for the slave port.