Filter
Top Products
EtherHub 1500 System User’s Guide
4-12 Setup and Configuration
Control Menu
Hub
Port
Backup Port
Push Button
Includes hub description and commands to
isolate/reattach network connection, or
assign hub to a specified segment.
Includes port description and command to
enable/disable selected port.
Defines master/slave port pairs used for
emergency backup.
Enables/disables external
Configure button
on selected hub.
Configuring Hub Parameters
Use the Hub command from the Control menu to configure any
hub in the stack. (Select the required hub using the <F4> and
<F5> function keys.) This menu provides a brief description of
the selected hub, and also allows you to isolate/reattach the hub
from the network.
Parameter Description
Hub ID Hub identifier within the stack. (Up to 10 hubs may be connected via the management channel.)
Note that hub IDs can only be assigned using the Configure button as described later in this chapter.
Position The physical position in the stack.
Name Any user-defined name for the selected hub.
Status
The stack connection may be set to ISOLATED or ATTACHED. Note that the Isolated LED will be lit
if the hub is isolated. (Although the status of OTHER is provided, this is for internal use only.)
Segment
Attach the hub to a specified segment. The appropriate Segment icon will light up to show that the
hub has been connected.
Type Indicates hub type as EH1501s, or EH1502s (Master or Slave).
Firmware Ver. Indicates the current firmware version number.