Filter
Top Products
EtherHub 1500 System User’s Guide
4-18 Setup and Configuration
Selections Available
This section shows the selections available for each function
and the corresponding LED display. The functions are listed
here in sequence.
Segment Setting
Active LEDs: Segment LEDs
Attach the hub to one segment.
Segment LED 1 Segment LED 2 Segment LED 3 Segment Number Selection
Blinking OFF OFF Attach hub to Segment 1 (DEFAULT)
OFF Blinking OFF Attach hub to Segment 2
OFF OFF Blinking Attach hub to Segment 3
Blinking Blinking Blinking Isolated from all segments*
Note: When the Isolated indicator on the front panel is lit, the segment indicators reflect the previous setting and should be ignored.
Hub ID Setting
Active LEDs: Hub ID LEDs
After setting the segment, the system enters the Hub ID function.
For initial configuration, the Hub ID LEDs will all be blinking
(automatic Hub ID Setting). Otherwise, you will see a combination
of blinking and OFF LEDs. Refer to the following table for the hub
ID Number and its corresponding LED display.
Hub ID LED 1 Hub ID LED 2 Hub ID LED 4 Hub ID LED 8 Hub ID Number Selection
BLINKING BLINKING BLINKING BLINKING Automatic Hub ID setting (DEFAULT).
BLINKING OFF OFF OFF Hub ID 1
OFF BLINKING OFF OFF Hub ID 2
BLINKING BLINKING OFF OFF Hub ID 3
OFF OFF BLINKING OFF Hub ID 4
BLINKING OFF BLINKING OFF Hub ID 5
OFF BLINKING BLINKING OFF Hub ID 6
OFF BLINKING BLINKING OFF Hub ID 6
BLINKING BLINKING BLINKING OFF Hub ID 7
OFF OFF OFF BLINKING Hub ID 8
BLINKING OFF OFF BLINKING Hub ID 9
OFF BLINKING OFF BLINKING Hub ID 10
Note: When the EtherHub-16mi
+
is in a stand-alone configuration, the Automatic Hub ID function will set it to Hub ID 1.